PWM ICs TL494 and 555 at TI

In addition, that you like testing jobs  a few, to allow them better sockelt to a light switch...
then hatter villt only 1/2 Fets...solte custom load you still the whole stuff un nen bd139/140 for the Treiberstufe...dan you prefer...So all in all would be but not sooo wrong...^^

To the actual topic: use just a voltage source with little power?
I for example son NT with 30Vdc 850mA to the arcen something modest but whre in about what you're looking for ^ ^
Otherwise try to wrap up a transformer which you're stuck between ZVS and DST...PRIM 3 + 3 coils sec. so around 20-50 with thicker cross-section (1 mm² or something)
Then on the DST a normal winding with 5Wdg or so un since the output of the transformer of ra
You order a few PWM ICs TL494 and 555 at TI ;) Just the gebraüchlichsten pick and have your 25 ICs, that's enough for a time first
So I have now even quite simple but not elegantly solved.
1R5 x 17W loads before the ZVS. So not only before the toroidal transformer.
The result is actually quite useful. The voltage should be about 25kV.
I have tested the current times. It go at 25V max 5A. Rather 4A.
So 100 up to 125W. What do you think this is still too much for the DST?

I would build a online PD  with 555 I'd Neuland enter I admit.
The ZVS Mazilli has become to my favorite circuit ^ ^
then I would say you can build on the circuit with the 555, it makes it fun to play. Especially light bulbs can elicit is interesting effects at different frequencies
The ZVS by Mazilli is ganu designed to deliver maximum benefits.
That is however, paradox with back conditions them to dampen: troll face:.
If you want to have less power take less voltage.